🔍 Key Findings

• 20 dogs (26 shoulders) evaluated at mean 3.5 years post-surgery after arthroscopic or open debridement.
• Ipsilateral muscle atrophy and decreased range of motion (↓ extension, ↓ flexion) in affected limbs compared to contralateral healthy shoulders.
• All treated shoulders developed osteoarthritis, confirmed radiographically, by CT, and arthroscopically.
• Moderate to severe synovitis was present in all shoulders; lesions showed patchy, incomplete cartilage infilling even up to 8.9 years post-op.
• Kinetic gait analysis showed no significant differences in PVF/VI between affected and unaffected limbs, despite mild lameness clinically.
• Owners reported good to very good mobility (median LOAD = 6), often underestimating clinical lameness.
• CT detected larger lesion dimensions than radiographs (wider, deeper defects).
• Despite progression of OA, surgical debridement was associated with satisfactory long-term function, though not prevention of degenerative changes.

🔍 Key Findings

• A positive meniscal flounce sign was associated with normal menisci in 95.5% of cases, demonstrating strong predictive value.
• Absence of the meniscal flounce sign was associated with meniscal tears in 92.7% of cases.
• Overall diagnostic accuracy of the flounce sign was 94.6%, with 96.6% sensitivity and 90.5% specificity.
• Most tears in flounce-negative stifles were bucket-handle tears (73.8%), while radial tears were present in some flounce-positive stifles.
• Radial tears did not consistently eliminate the flounce sign, suggesting they may not disrupt meniscal fiber tension sufficiently.
• All procedures were arthroscopically performed, with probing and visualization of the medial meniscus' caudal pole.
• Flounce sign should complement, not replace, probing—especially as some tear types (e.g., radial) may not abolish the sign.
• Limb positioning and joint distraction may affect flounce visibility, introducing minor observer variability.

🔍 Key Findings

• Double-loop cerclage resisted the highest peak load (805 N) and maintained tension longer than twist (488 N) and single-loop (397 N) configurations.
• Double-loop cerclage sustained 500,000 cycles at 60–80% of peak load in some cases without loosening, outperforming other types.
• Twist knots loosened rapidly, often within 10 cycles even at low loads (100–390 N).
• Single-loop knots performed better than twist, with partial resistance up to 100,000 cycles at 160 N, but showed wide variability.
• All loosening occurred before wire breakage, indicating clinical failure would happen from slack, not fracture.
• Double-loop cerclage had highest initial tension (323 N) compared to single-loop (124 N) and twist (69 N).
• Fatigue limit was not identified for twist, since they all loosened early at even 20% of peak load.
• Clinical recommendation: double-loop cerclage is best for resisting repeated subfailure loading, ideal for fissure prevention or fragment stabilization.

🔍 Key Findings

Design: In vitro study on cadaveric femurs (n=21) with basilar femoral neck fractures stabilized using 2 vs 3 titanium cannulated screws.

Stiffness: Control > 3-screw > 2-screw (674 > 120 > 90 N/mm).

Yield Load: 3-screw (586 N) > 2-screw (303 N); both < intact femur (2692 N).

Displacement: No difference across groups.

Complication: 3-screw technique more demanding; higher risk of cortical perforation, especially with narrow femoral necks.

Failure Mode: Dislodgement of femoral head + screw shaft bending.

Conclusion: 3 screws = stronger construct than 2 screws. Clinical implications need further study.

🔍 Key Findings

• Intra- and postoperative complications occurred only in stapled lobectomies, but the difference was not statistically significant (intra: p = .069, post: p = .112).
• Intraoperative hemorrhage was the most common complication (11.8%), followed by air leakage (2%).
• All self-ligating loop (SLL) lobectomies had zero complications (n=18), though the sample was small.
• Postoperative complications included 4 catastrophic events (cardiopulmonary arrest), all in stapled cases.
• Lung lobectomy technique was not associated with duration of chest tube use, hospitalization, or survival (p > .05).
• 94.3% of patients survived to discharge (82/87).
• SLLs are lower-cost and may be more feasible for thoracoscopic/minimally invasive approaches due to smaller port size (5mm vs. 12mm for staplers).
• A future superiority study would need ≥103 lobectomies per group to assess differences in complication rates.

🔍 Key Findings

• 67.9% of respondents reported using SSCs, with most indicating frequent use (64% used in every surgery).
• 78.7% agreed SSCs reduce complications, and 89.6% believed SSCs improve communication.
• Respondents not using SSCs were more likely to view them as a waste of time (p < .001).
• Forgetfulness (39.6%) and time constraints (36.5%) were leading reasons for checklist noncompletion.
• Only 23.3% had SSC training during surgical residency, with newer diplomates more likely to have had exposure (p < .001).
• Key strategies to improve uptake included: staff feedback modifications (67.9%), formal designation of initiator (48.6%), and training (52.2%).
• Surgeons and OR staff were most commonly identified as noncompliant team members.
• SSC use was more frequent in small animal practices, and mandating SSCs by management was favored but not always effective alone.

🔍 Key Findings

• No leakage occurred using pretied ligature loops (PLL) or double-shank (DS) titanium clips up to 40 cm H₂O airway pressure.
• 1/10 stapled lobes leaked at supraphysiologic pressure (40 cm H₂O), but this was not statistically significant (p = .33).
• All techniques sealed effectively under physiologic and supraphysiologic pressures in cadaveric feline lungs.
• PLL and DS clips required less working space than staplers, making them more practical for small thoracic cavities.
• DS titanium clips offer enhanced security due to dual shanks and tissue-gripping design, reducing clip slippage.
• Leak testing was cyclic and submerged, simulating physiologic ventilation and allowing robust evaluation.
• Stapling failure occurred along the staple line, highlighting risks of air leakage due to staple misalignment or poor hilar access.
• PLL and DS clips may be cost-effective and efficient alternatives for open or minimally invasive feline lung lobectomy.

🔍 Key Findings

• Compared unilateral plating (UP) vs orthogonal plating (OP) with 2.0, 2.4, and 3.0 mm plates (OP2.0, OP2.4, OP3.0).
• Model: acetal homopolymer (Delrin) rod with 29 mm fixed fracture gap, loaded axially (4–196 N, 90,000 cycles).
• OP constructs had 2.5–4.1x higher strength and 3.0–4.2x higher stiffness than UP constructs (p < .0002).
• UP had 3.5–4.1x higher gap strain than OP groups (p < .0075).
• All OP groups exceeded 1000 N max load before failure (vs 424 N for UP).
• Greater implant size in OP groups further increased performance.
• All constructs survived fatigue loading; 3.5 mm plates showed deformation, especially UP; OP plates remained intact.

🔍 Key Findings Summary

• Finite element analysis compared intact radii vs. locking plates placed 1 mm or 3 mm above the bone
• LP placement significantly reduced tensile (maximum principal) stress on cranial cortex, potentially causing implant-induced osteoporosis
• Shell element findings:
  • Max principal stress significantly lower in both LP groups vs. intact (p < 0.05)
• Solid element findings:
  • Equivalent stress higher and max principal stress lower in LP groups
• Implication: Tension reduction may impair bone remodeling; implant design and placement height affect stress environment

🔍 Key Findings

• All dogs (11/11) showed improved radiohumeral articulation postoperatively, confirmed arthroscopically.
• Median shortening: radioulnar (3.2 mm), humeroradial (1.8 mm), humeroulnar (1.2 mm).
• Median lameness score improved from 2/4 to 1/4 by final follow-up.
• Bone healing achieved in a median of 8 weeks (range: 4–14 weeks).
• No major complications; minor issues included 1 screw loosening and 1 superficial infection.
• Subjective function was graded full in 4 dogs, acceptable in 7.
• Arthroscopy enabled accurate dynamic joint assessment, preferred over static radiographs.
• Use of both orthopedic wire and plating provided secure fixation and improved outcomes.