🔍 Key Findings

• All four arthrocentesis techniques achieved 100% intra-articular accuracy, confirming that each landmark-guided method could successfully access the canine stifle joint.
• Lateral intercondylar notch (LINC) was the most commonly used technique clinically, reported by 87.5% (35/40) of surveyed surgeons.
• INFRA and SUPRA required significantly more needle repositions (median 3 and 2) compared with LINC and POUCH (median 1) (p = .001).
• No iatrogenic articular cartilage injury (IACI) occurred with LINC or SUPRA techniques, suggesting favorable safety profiles.
• INFRA produced the highest IACI rate (75%), with 6/8 limbs affected, indicating substantial risk with this approach.
• More than half of INFRA injuries exceeded 10 mm² and involved weight-bearing cartilage, raising concern for clinically significant joint damage.
• POUCH technique caused IACI in 37.5% of cases, but injuries occurred exclusively on non-weight-bearing cartilage.
• SUPRA (suprapatellar) approach demonstrated accuracy with zero cartilage injury, making it a promising safer alternative for stifle arthrocentesis pending clinical validation.

🔍 Key Findings

• Fascia lata autograft reconstruction of the FCU tendon successfully treated carpal hyperextension in both dogs.
• Primary repair was not possible in one dog due to complete rupture; a fascia lata graft bridged the tendon gap.
• In the second case, elongated tendon was corrected and reinforced with fascia lata to prevent recurrence.
• Type I external skeletal fixation was used for 6 weeks to support tendon healing in both dogs.
• Postoperative gait and range of motion returned to normal, with no recurrence at 36-month follow-up.
• Ultrasonography aided diagnosis, revealing thinning and echogenic changes in the FCU tendon.
• Histologic findings showed mild, nonspecific muscle changes, suggesting injury rather than a systemic disease.
• No complications occurred, and fascia lata showed potential for biological integration and remodeling into tendon-like structure.

🔍 Key Findings

Incidence of BFX lateral bolt stem breakage: 2.95% (13 dogs, 14 stems)

Implant factors:

• 13/14 were BFX lateral bolt stems (sizes #5–7)
• +9 necks used in 5/11 of 17 mm heads
• 10/14 stems undersized based on radiographs
• 10/13 dogs exceeded weight limits for implanted stem size

Malalignment:

• 10/14 had varus alignment (median 3.9°)
• 8/14 had insufficient proximodistal seating

Breakage site: Proximolateral shoulder in all cases

Revision outcomes:

• 11 revised (7 CFX, 3 larger BFX, 1 collared)
• 9/10 revised dogs regained full function
• Complications: 1 rebreakage, 1 periprosthetic fracture, 1 fixation failure

Histopathology:

• Electron microscopy showed fatigue striations and incomplete bead fusion

Conclusion: Avoid small BFX lateral bolt stems if undersized or if long necks required; use weight guidelines to prevent fatigue failure.

🔍 Key Findings

• Ventral Compression Index (VCI) ≥0.16 (extension) or ≥0.2 (flexion) was diagnostic for AAI with 100% sensitivity and >94% specificity
• VCI had the highest diagnostic accuracy among all measured variables (AUC > 0.99)
• C1-C2 overlap ≤2.7 mm (extension) or ≤1.8 mm (flexion) also diagnostic for AAI (sensitivity 84–96%, specificity 81–90%)
• C1-C2 angle ≥176.9° (extension) or ≥187.4° (flexion) had high sensitivity and specificity (~95%)
• Basion-dens interval ≥5.9 mm (extension) or ≥3.0 mm (flexion) provided moderate diagnostic accuracy
• Cranial translation ratio (CTR) ≥0.18 classified dogs as potentially unstable (sensitivity 90%, specificity 78%)
• VCI ≥0.23 reliably differentiated AAI from potentially unstable cases (sensitivity 94%, specificity 94%)
• DALR ≤0.24 had high specificity (100%) but low sensitivity for AAI diagnosis

🔍 Key Findings

• Adding Locking Head Inserts (LHI) to a 3.5-mm LCP had no effect on plate strain, stiffness, or deformation in an open fracture gap model.
• Peak strain consistently occurred at the Combi-hole over the fracture gap, with values up to ~1837 µε.
• No significant difference in strain was found across configurations with 0, 3, or 9 LHI (p = 0.847).
• Construct stiffness and compressive displacement also remained unchanged regardless of LHI count (p = 0.311 and 0.069 respectively).
• Study contradicted the hypothesis that LHI would reduce strain and increase stiffness under biologic loading.
• Combi-hole design may limit the efficacy of LHI, as LHI only fill the locking portion, not the compression side where strain peaks.
• Implant fatigue risk remains highest over unfilled screw holes, especially over fracture sites—confirming previous failure patterns.
• Surgeons should consider alternative methods to reduce strain when facing high implant load scenarios.

🔍 Key Findings

• First reported case of total cystectomy and bilateral cutaneous ureterostomy in a cat using a modified Toyoda technique.
• Histologically complete tumor resection was achieved, with tumor-free ureter and urethral margins >20 mm.
• The modified Toyoda technique involved shaping the ureter into a fish-mouth aperture and anastomosing it to a rectangular skin defect for stomal formation.
• Incontinence was managed using a diaper changed every 6–8 hours, with no dermatological complications.
• Obstruction of the right ureter occurred 14 months post-op, associated with a subcutaneous nodule at the anastomosis site.
• Despite incontinence, owner satisfaction and perceived quality of life were high, with the cat living ~16 months post-op.
• The stents were removed on days 7 (left) and 28 (right) postoperatively, with initial patency maintained until 14 months.
• This surgical approach may offer palliative or curative benefit for feline trigonal TCC where partial cystectomy is not feasible.

🔍 Key Findings

• Compared unilateral plating (UP) vs orthogonal plating (OP) with 2.0, 2.4, and 3.0 mm plates (OP2.0, OP2.4, OP3.0).
• Model: acetal homopolymer (Delrin) rod with 29 mm fixed fracture gap, loaded axially (4–196 N, 90,000 cycles).
• OP constructs had 2.5–4.1x higher strength and 3.0–4.2x higher stiffness than UP constructs (p < .0002).
• UP had 3.5–4.1x higher gap strain than OP groups (p < .0075).
• All OP groups exceeded 1000 N max load before failure (vs 424 N for UP).
• Greater implant size in OP groups further increased performance.
• All constructs survived fatigue loading; 3.5 mm plates showed deformation, especially UP; OP plates remained intact.

🔍 Key Findings

• Laparoscopic ISLN removal using NIRF-ICG was feasible in 89% of dogs (16/18), demonstrating high procedural success with minimal invasiveness.
• Median laparoscopic dissection time was only 12 minutes, suggesting efficiency of the NIRF-guided approach.
• No postoperative complications were observed, and intraoperative complications occurred in only 2 dogs (11.1%), both requiring conversion to open surgery.
• Metastatic disease was confirmed in 48% of patients (12/25 nodes), including cases where LNs appeared normal in size, highlighting the value of histologic evaluation.
• NIRF-ICG enabled precise identification of small and mildly enlarged nodes, which are often missed during traditional imaging or palpation.
• Fluorescent dye leakage following LN capsule rupture limited visibility and required surgical conversion, indicating a key limitation of the technique.
• ICG signal was occasionally absent in metastatic LNs, likely due to lymphatic rerouting or obstruction, underscoring limitations in SLN identification.
• The lateral approach allowed consistent access to ipsilateral MILN, IILN, and sacral LNs, though contralateral nodes were inaccessible with this method.

🔍 Key Findings

• Double plate fixation significantly increased construct stiffness (563.7 vs 392.8 N/mm; p < .0001), supporting superior biomechanical stability
• Displacement was significantly reduced with double plating (−0.48 mm vs −0.81 mm; p < .0001), indicating improved resistance to cyclic loading
• No difference in primary plate strain between single and double constructs, suggesting load-sharing did not reduce plate stress
• Caudolateral placement of the second plate enhances biomechanical advantage by increasing moment arm and resisting tensile forces
• Cyclic loading model (7200 cycles) simulated 1 hour of walking, making findings clinically relevant to early postoperative activity
• Strain across fracture gap was lower in double plate constructs (~4.3% vs ~6.9%), supporting improved conditions for fracture healing
• No construct failures occurred, but actuator slippage occurred only in double plate group, highlighting potential testing/artifact considerations
• Clinical implication: double plating may allow earlier weightbearing and reduce need for external coaptation, improving recovery outcomes